Reading a service notification
With the ignition switched on, the engine off
and the vehicle at a standstill, the current
service notification can be read:
Press and hold the button
seconds to consult the service message.
When the service date has passed, a minus
sign is displayed in front of the number of kil-
ometres or days.
Vehicles with text messages: the following
message is displayed: Service --- km
(miles) or --- days ago
The time can also be set via the
function button in the Easy Connect
Setup
›››
system
page
107.
Resetting service interval display
If the service was not carried out by a SEAT
dealership, the display can be reset as fol-
lows:
●
Switch off the ignition, press and hold but-
›››
ton
Fig. 121
.
4
●
Switch ignition back on.
›››
●
Release THE
4
press it again for the next 20 seconds.
Note
●
The service message disappears after a few
seconds, when the engine is started or when
34
OK/RESET
lever, or
wheel.
In vehicles with the LongLife system in
●
which the battery has been disconnected for
for more than 5
4
a long period of time, it is not possible to cal-
culate the date of the next service. Therefore
the service interval display may not be cor-
rect. In this case, bear in mind the maximum
service intervals permitted in the
let Maintenance
.
Cruise control
key and
Operating the cruise control system
(CCS)*
Fig. 121
button and
Fig. 41
●
Switching on the CCS: Move switch
›››
Fig. 41
The essentials
is pressed on the windscreen wiper
on the multifunction steering
OK
›››
Book-
Programme.
See position on page 7-8
to . The system is on. If no
1
speed has been programmed, the system will
not control it.
●
Activating the CCS: Press button
in the area. The current speed is
2
memorised and controlled.
●
Temporarily switching off the CCS: Move
›››
switch
Fig. 41
to or push the
1
brake. The cruise control system is switched
off temporarily.
●
Reactivating the CCS: Press button
›››
Fig. 41
in . The memorised speed
2
is saved and controlled again.
Increasing stored speed during CCS regula-
●
tion: press button
in . The vehicle ac-
2
celerates until the new stored speed.
●
Reducing stored speed during CCS regula-
tion: press button
in to lower the
2
speed by 1 km/h (1 mph). Speed is reduced
until reaching the new stored speed.
●
Switching off the CCS: Move switch
›››
Fig. 41
to . The system is disconnec-
1
ted and the memorised speed is deleted.
›››
in Operation on page 184
›››
page 184
›››
Fig. 41