CAUTION
To prevent damage to the engine, the rev
●
counter needle should only remain in the red
zone for a short period of time.
When the engine is cold, avoid high revs
●
and heavy acceleration and do not make the
engine work hard.
For the sake of the environment
Changing up a gear in time reduces fuel con-
sumption and noise.
Rev counter
The rev counter indicates the number of en-
›››
gine revolutions per minute
Fig. 121
Together with the gear-change indicator, the
rev counter offers you the possibility of using
the engine of your vehicle at a suitable
speed.
The start of the red zone on the dial indicates
the maximum engine speed which may be
used briefly when the engine is warm and af-
ter it has been run in properly. Before reach-
ing this range, you should change to a higher
gear for vehicles with a manual gearbox or for
automatic gearboxes put the selector lever in
"D" or take your foot off the accelerator ped-
al.
Instruments and warning/control lamps
We recommend that you avoid high revs and
that you follow the recommendations on the
gear-change indicator. Consult the additional
›››
page 28, Gear-change
information in
indicator.
CAUTION
Never allow the rev counter needle
›››
Fig. 121
to go into the red zone on the
scale for more than a very brief period, other-
wise there is a risk of engine damage.
For the sake of the environment
Changing up a gear early will help you to save
fuel and minimise emissions and engine
noise.
.
1
Indications on the display
A variety of information can be viewed on the
instrument panel display
pending on the vehicle equipment:
●
Bonnet, rear lid and doors open
›››
page
28.
●
Information and warning texts.
●
Mileage.
●
Time.
●
Navigation instructions.
●
Outside temperature.
●
Compass.
●
Shift lever position
Recommended gear (manual gearbox)
●
›››
Multifunction display (MFD) and menus
●
with different setting options
●
Service interval display
●
Second speed display
1
Speed warning function
●
●
Start-Stop system status display
›››
page
●
Low consumption driving status (ECO)
›››
page 98
●
Identifying letters on engine (MKB).
●
Active cylinder management display
®
(ACT
)*
Distance travelled
The odometer registers the total distance
travelled by the car.
›››
Fig. 121
de-
3
The odometer ( trip ) shows the distance
travelled since the last odometer reset. The
last digit of the trip recorder indicates distan-
ces of 100 metres or one tenths of a mile.
●
Briefly press the button
set the trip recorder to 0.
●
Keep the button
seconds and the previous value will be dis-
played.
›››
page
159.
page
28.
›››
page
›››
page
›››
page
25.
›››
page
173.
›››
page 167
›››
Fig. 121
pressed for about 3
4
25.
33.
32.
to re-
4
»
97