Make sure that the head restraint engages
–
securely in one of its positions
Removing the head restraint
Push the head restraint up as far as it will
–
go.
›››
Press the button
Fig. 141
–
Pull head restraint out of fitting without re-
–
leasing the button.
Fitting the head restraint
Insert the head restraint into the guides on
–
the corresponding backrest.
Push head restraint down.
–
Adjust the head restraint to suit body size
–
›››
page
60.
WARNING
Never drive if the head restraints have been
●
removed. Risk of injury.
●
Never drive if the head restraints are in an
unsuitable position (the lowest position) as
there is a risk of serious injury.
●
After refitting the head restraint, you must
always adjust it properly for height to achieve
optimal protection.
●
Please observe the safety warnings in
in Correct adjustment of front head restraints
on page
60.
134
Note
›››
page
60.
●
To fit and remove the rear head restraints,
gently tilt the seat backrest forwards.
When fitting the head restraints again, in-
●
sert the tubes as far as possible into the
guides without pressing the button.
(arrow).
Seat functions
Heated seats*
Front seat heating switch.
Fig. 142
The front seat cushions and backrests can be
heated electrically.
Press the corresponding switch
–
›››
to switch on the seat heating.
Press once to connect the heating at maxi-
–
mum force. The two LEDs illuminate
›››
Fig.
142. After 15 minutes of high inten-
Operation
›››
Fig. 142
sity, the upper LED goes out, the system is
deactivated for 2 minutes and is then reac-
tivated at low intensity (the lower LED re-
mains on permanently).
Press the switch again to set the heating to
–
minimum force. (The lower LED lights up).
To disconnect the heating, press the switch
–
again.
CAUTION
To avoid damaging the heating elements,
please do not kneel on the seat or apply
sharp pressure at a single point to the seat
cushion and backrest.
Note
The seats are only heated electrically when
the engine is running.