Seat ibiza Owner's Manual page 123

door. The other doors each have a switch for
their own window.
Always close the windows fully if you park
the vehicle or leave it unattended
You can use the electric windows for approx.
10 minutes after switching off the ignition if
neither the driver door nor the front passen-
ger door has been opened and the key has
not been removed from the ignition.
Safety switch not pressed: buttons on rear
doors are activated.
Safety switch pressed: buttons on rear doors
are deactivated.
WARNING
›››
Observe the safety warnings
keys on page 116.
● Incorrect use of the electric windows can
result in injury.
● Never close the rear lid without observing
and ensuring it is clear, to do otherwise could
cause serious injury to you and third parties.
Make sure that no one is in the path of a win-
dow.
If the ignition is switched on, the electric
●
equipment could be activated with risk of in-
jury, for example, in the electric windows.
● The doors can be locked using the remote
control key. This could become an obstacle
for assistance in an emergency situation.
Opening and closing
Always take the key with you when you
●
leave the vehicle.
● The electric windows will work until the ig-
nition has been switched off and one of the
›››
.
front doors has been opened.
● If necessary, use the safety switch to disa-
ble the rear electric windows. Make sure that
they have been disabled.
Note
If the window is not able to close because it
is stiff or because of an obstruction, the win-
dow will automatically open again
›››
page 121. If this happens, check why the
window could not be closed before attempt-
ing to close it again.
in Set of
One-touch opening and closing*
One-touch opening and closing means you
do not have to hold down the button.
›››
Buttons Fig. 133
two positions for opening windows and two
for closing them. This makes it easier to open
and close windows to the desired position.
One-touch closing
Pull up the window button briefly up to the
–
second position. The window closes fully.
One-touch opening
Push down the window button briefly up to
–
the second position. The window opens
fully.
Restoring one-touch opening and closing
The automatic open and close function will
–
not work if the battery has been temporari-
ly disconnected. The function can be re-
stored as follows:
Close the window as far as it will go by lift-
–
ing and holding the electric window switch.
Release the switch and then lift it again for
–
1 second. This will re-enable the automatic
function.
If you push (or pull) a button to the first
stage, the window will open (or close) until
you release the button. If you push or lift the
button briefly to the second stage, the win-
dow will open (one-touch opening) or close
(one-touch closing) automatically. If you op-
erate the button while the window is opening
, , and have
1 2 4 5
or closing, it stops at this position.
Roll-back function
The roll-back function reduces the risk of in-
jury when the electric windows close.
»
121