Seat ibiza Owner's Manual page 94

Number plate light
3 Applies to the model: IBIZA/IBIZA SC
Insert the flat part of a screwdriver into the
–
special slot and remove the bulb.
Remove the bulb holder, by turning it until
–
it is free.
Change the bulb.
–
Replace the bulb holder, by turning it until
–
it fits fully.
Fit the light into the space and press until
–
you hear a "click".
Number plate light
3 Applies to the model: IBIZA ST
Remove the number plate light.
Fig. 116
Insert the flat part of a screwdriver into the
–
special slot and remove the number plate
light from its moulding.
92
Emergencies
Remove the connector and extract the bulb.
–
After changing the bulb, fit the connector
again.
Place the light in its moulding, pressing the
–
left side. Once it is fitted into place, press
the right side until you hear a "click".
Additional brake light*
Given the difficulty involved in the replace-
ment of this light it should be done by Tech-
nical Services.
Interior light and front reading lights
Front reading light.
Fig. 117
To remove the glass
Insert a fine screwdriver between the cas-
–
›››
ing and the glass Fig. 117.
Carefully remove the glass, levering it to
–
avoid possible damage.
To replace the bulbs
Pull the bulbs outwards.
–
To remove the central bulb, hold and press
–
to one side.
Assembly
Proceed in the reverse order, pressing gen-
–
tly on the outer edge of the side light.
First fit the glass with the fastening tabs
–
over the frame of the switch. Next press the
front part until the two long tabs click on
the support.