Trunk Configuration Menu - Panasonic PN28248 Operation Manual

4.6.2.b.

Trunk Configuration Menu

On the Advanced Switch Configuration Menu, pressing "L" opens the Trunk Con-
figuration Menu screen, as shown in Fig. 4-39. On this screen, you can configure
the link aggregation settings.
PN28248 Local Management System
Advanced Switch Configuration -> Trunk Configuration Menu
System Priority : 1
Key Mode
----- -------- ---------------------------------------------------------------
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Se[t] System Priority [M]odify Group Mode
Command>
Screen Description
System Priority System priority is an order of priority in this Switching Hub required for construct-
ing trunking on the network using LACP. Smaller number has higher priority. The
factory default setting is 1.
Key Indicates the group number of trunking.
Mode Indicates the operation mode of trunking.
Active
Passive
Manual
Members Port Indicates the port belonging to trunking group.
List
Note: If each Switching Hub uses LACP passive mode, LACP negotiation is not exe-
cuted then the packet storm may be occurred. When constructing trunking
using LACP, make sure to configure one side to be Active.
Member Port List
[A]dd Group Member
[R]emove Group Member
Fig. 4-39 Link Aggregation Menu
Sends out LACP packet from this Switching Hub and constr
ucts a trunk by negotiating with other side. It is required that
the other side mode is Active or Passive.
Does not send out LACP packet from this Switching Hub and
constructs a trunk by negotiating with other side using LACP
packet received from other side. It is required that the other
side mode is Active.
Constructs trunking forcibly without using LACP packet. It is
required that the other side is the same configuration as this
side.
97
Set P[o]rt Priority
LACP [G]roup Status
[Q]uit to previous menu