Trunk Configuration - Panasonic Switch-M12PWR Operation Manual

4.7.2.b. Trunk Configuration
On the Advanced Switch Configuration Menu, pressing "L" opens the Trunk
Configuration Menu screen, as shown in Fig. 4-7-8. In this screen, you can
configure trunking.
PN23129K/PN23129A Local Management System
Advanced Switch Configuration -> Trunk Configuration Menu
System Priority : 1
Key Mode
----- -------- ---------------------------------------------------------------
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Se[t] System Priority [M]odify Group Mode
Command>
Enter the character in square brackets to select option
Screen Description
System System priority is an order of priority in this Switching Hub required for
Priority constructing trunking on the network using LACP. Smaller number has
higher priority. The factory default setting is 1.
Key Indicates the group number of trunking.
Mode Indicates the operation mode of trunking.
Active
Passive
Manual
Members Port Indicates the port belonging to trunking group.
List
Member Port List
[A]dd Group Member
[R]emove Group Member
Fig. 4-7-8 Trunk Configuration
Sends out LACP packet from this Switching Hub and
constructs a trunk by negotiating with other side.
It is required that the other side mode is Active or
Passive.
Does not send out LACP packet from this Switching
Hub and constructs a trunk by negotiating with other
side using LACP packet received from other side.
It is required that the other side mode is Active.
Constructs trunking forcibly without using LACP
packet. It is required that the other side is the same
configuration as this side.
92
Set P[o]rt Priority
LACP [G]roup Status
[Q]uit to previous menu