Table of Contents
Advertisement
4.7. Statistics
On the Main Menu, pressing "S" opens the Statistics Menu screen as shown in Fig.
4-77. On this screen, you can monitor the number of packets as statistics informa-
tion of the Switching Hub and thereby keep an eye on the network status. In addi-
tion, monitoring of error packets allows you to segregate failures.
PN28248 Local Management System
Main Menu -> Statistics Menu
Port: 1
<Counter Name>
Total RX Bytes
Total RX Pkts
Good Broadcast
Good Multicast
CRC/Align Errors
Undersize Pkts
Oversize Pkts
Fragments
Jabbers
Collisions
64-Byte Pkts
65-127 Pkts
128-255 Pkts
256-511 Pkts
512-1023 Pkts
Over 1024 Pkts
-------------------------------- <COMMAND> -----------------------------------
[N]ext [P]revious [S]elect Port Re[f]resh Mode Since [R]eset [Q]uit
Command>
Enter the character in square brackets to select option
Fig. 4-77 Statistics: Values Accumulated after Reboot
Screen Description
Port
Refresh
Elapsed Time Since
System Up
Counter Name
Total
Avg./s
Available commands are listed below.
S
Switch the port to display the values.
Press "S." The command prompt changes to "Select Port number>." Enter the port number
for which you wish to display values.
N
Display the values of the next port.
Press "N." The screen displays the counter values of the next port. The command is invalid
for Port 18.
P
Display the values of the previous port.
Press "P." The screen displays the counter values of the previous port. The command is
invalid for Port 1.
Refresh: 300 Sec.
<Total>
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Displays the port number.
Displays the refresh interval. (The factory default setting is 300 seconds)
Displays this Switching Hub's reboot time.
Displays each counter name.
Displays each counter value.
Displays the average value per second of each counter.
Elapsed Time Since System Up: 000:06:28:03
<Avg./s>
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
163
Advertisement
Table of Contents
