4.5.3.b.
SNMP Trap Receiver Configuration
On the SNMP Configuration Menu, pressing "T" opens the SNMP Trap Receiver
Configuration Menu screen, as shown in Fig. 4-12. On this screen, you can config-
ure the SNMP Trap settings.
PN28248 Local Management System
SNMP Configuration -> SNMP Trap Receiver Configuration Menu
Trap Receiver List:
No.
Status
---- --------
1
Disabled
2
Disabled
3
Disabled
4
Disabled
5
Disabled
6
Disabled
7
Disabled
8
Disabled
9
Disabled
10
Disabled
-------------------------------- <COMMAND> -----------------------------------
Set Receiver [S]tatus
Set Trap [T]ype
Command>
Enter the character in square brackets to select option
Screen Description
Trap Receiver List: Displays the IP addresses and the community names for the current trap
receivers.
No.
Status
Type
IP Address
Community
Type
IP Address
-----
---------------
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
Set Receiver [I]P
Set Receiver [C]ommunity
Fig. 4-12 SNMP Trap Receiver Configuration
Displays the entry number for the trap receiver.
Displays the trap sending setting.
Enabled
Disabled
Displays the type of traps.
V1
V2
Displays the IP address of the trap receiver.
Displays the current community name, set for sending
traps.
Community
----------------------------
In[d]ividual Trap Config
[Q]uit to previous menu
Sends traps.
Does not send traps.
Sends traps of SNMP v1.
Sends traps of SNMP v2.
43