Table of Contents
Advertisement
4.5.7.d.
SSH Server Configuration
On the System Security Configuration Menu, pressing "H" opens the SSH Server
Configuration screen, as shown in Fig. 4-21. On this screen, you can configure the
SSH server settings.
This Switching Hub only supports SSHv2. Use a client that supports SSHv2 and
connect to it.
PN28248 Local Management System
Basic Switch Configuration -> SSH Server Configuration
SSH UI Idle Timeout:
SSH Auth. Idle Timeout:
SSH Auth. Retries Time:
SSH Server:
SSH Server key:
-------------------------------- <COMMAND> -----------------------------------
[G]enerate SSH Server key
Set SSH UI Time [O]ut
Set SSH Authentication [R]etries Time [Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
SSH UI Idle Timeout:
SSH Auth. Idle Timeout:
SSH Auth. Retries Time:
SSH Server:
SSH Server key:
5 Min.
120 Sec.
5
Disabled
Key exists.
Enable/Disable SS[H] Server
Set SSH [A]uthentication Time Out
Fig. 4-21 SSH Server Configuration
Displays the idle timeout settings (in minutes) for terminating a SSH-
connected session if no input is made.
The factory default setting is 5 minutes.
Displays the time to wait for a response to SSH authentication.
The factory default setting is 120 seconds.
Displays the number of times of retransmission of SSH authentication.
The factory default setting is 5.
Displays the SSH access settings.
"Disabled" is the factory default setting.
Enabled(SSH)
Disabled
Displays the SSH server key status.
Key exists.
Key does not exist.
65
Access is enabled.
Access is disabled.
The server key exists.
The server key does not exist.
Advertisement
Table of Contents
