Table of Contents
Advertisement
4.5.2.b.
Trunk Configuration Menu
On the Advanced Switch Configuration Menu, pressing "L" opens the Trunk Con-
figuration Menu screen, as shown in Fig. 4-16. On this screen, you can configure
the trunking settings.
PN25249 Local Management System
Advanced Switch Configuration -> Trunk Configuration Menu
Key
Mode
----- -------- ---------------------------------------------------------------
1 Manual 5-6
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Command>
Enter the character in square brackets to select option
Screen Description
Key
Displays the group number of trunking.
Mode
Displays the operation mode of trunking.
Manual
Members Port
Displays the port belonging to the trunking group.
List
Available commands are listed below.
N
Display the next page.
Press "N" to display the next page.
P
Display the previous page.
Press "P" to display the previous page.
A
Configure new trunking settings.
1. Press "A." The command prompt changes to "Enter trunk group admin key>." Enter the
group number you wish to configure.
2. The command prompt changes to "Enter port member for group key #>." Enter a port
number for which you wish to execute trunking. When entering two or more port num-
bers, separate them with a comma without a space, or use a hyphen for consecutive
numbers.
Member Port List
[A]dd Group Member
[R]emove Group Member
Fig. 4-16 Trunk Configuration
Constructs trunking forcibly without using a LACP packet. The
other side should have the same configuration as this side.
73
[Q]uit to previous menu
Advertisement
Table of Contents
