Starter Motor; Steering Wheel And Horn Switches; Column Switches - Aston Martin DB7 Workshop Manual

Electrics
Starter Motor / Steering Wheel - Removal Procedures
^n:M3^^2?
6.3.02 Starter Motor
Procedure
1. Disconnect the battery.
2. Remove the inlet air trunkins
Figure 1. Starter Motor Mountings
3. Disconnect the starter solenoid connector and the
starter motor power lead at the solenoid.
4. Remove the top starter motor securing bolt.
Note: The top bolt is from tlie engine side on auto cars
and from ttie gearbox side on manual cars.
5. Raise the car on a hoist and whilst supporting the
motor, remove the lower starter motor securing
bolt.
6. Lift the motor from the bell housing and remove it
from the vehicle by positioning it vertically and
lowering it down in front of the oil filter.
6.5.01 Steering Wheel and Horn Switches
Procedure
1. Remove the steering wheel centre pad.
Figure 1. Steering Wheel and Horn
2. Mark the position of the steering wheel relative to
the steering column to ensure correct replacement.
3. Removethesteeringwheelsecuringnutand remove
the steering wheel.
6.5.02 Column Switches
Procedure
1. Remove the steering wheel.
2. Remove three screws and the column switch cover.
1 ^
Figure 1. Column Mounted Switches
3. Cut the tywraps securing the switch loom to the
steering column. Disconnect the loom plugs.
4. Release 4 screws and 1 ift the switch assembly off the
steering column.
6-6
May 1996