Changing The Dust Filter; Support Arm Adjustment; Via Carrying Case - Aston Martin DB7 Workshop Manual

^ ?
The Aston Martin Lagonda Diagnostic System
Installation Instructions
1. Switch off the PDU and remove all cables.
2. Remove the cover screw (Fig 23) and remove the cover.
3. If damaged, remove the old foam gasket from the cover and replace with the new one supplied.
4. Note the orientation of the connector. Disconnect the connector and remove the old battery pack.
5. Fit and connect the new battery pack (Fig 24) with the black cable towards the touch screen.
6. Refit the cover and cover screw.
7. Refer to the Battery Charging instructions for recharging times.
Changing the Dust Filter
The electronic module has a dust filter fitted to the underside of the module. Every three months a new filter w i l
be supplied. To change the filter, proceed as follows:
1. Switch off the mains supply and pull out the old filter (Fig 25).
2. Feed in the new filter with the blue side facing in, pushing it well into the corners of the holder.
3. Switch on the mains supply.
Figure 25. Dust filter replacement Figure 26. Support arm adjustment
Support A r m Adjustment
Periodically the support arm mechanism may require adjustment.
1. Remove the cross head arm fixing screw.
2. Using a suitable screwdriver, turn the tensioning screw (Fig 26) anti-clockwise half a turn.
3. Refit the leg fixing screw and repeat the operation on the opposite side.
4. Check that the arm tension is enough to support the weight of the PDU without movement.
V I A Carrying Case
The VIA unit (0018) is secured into its carrying case with two fixing screws from the underside of the case. If a new
VIA is required, remove the two fixing screws and lift the VIA from the carrying case. Return only the VIA for
replacement, do not return the carrying case.
May 1996 9-23