Airbag Dm Fault Code 35 - Aston Martin DB7 Workshop Manual

Electrics
Airbag System
^^?
Airbag DM Fault Code 35
Passengers airbag circuit low resistance or short
circuit.
Normal Operation
The diagnostic module measures the resistance
across pins 2-2 and 2-3 every time the ignition is
switched on. The resistance should be 0.9 to 1.1Q..
If the total resistance in the passengers airbag
circuit falls below 0.7S2, fault code 35 will be
declared and the airbag lamp will be illuminated.
f^ote: The nominal resistance of the airbag simulator is
2.5£2, therefore expect a total circuit resistance reading of
2.4 - 2.6Q with the simulator fitted.
Caution: The passengers airbag connector contains
shorting bars which short circuit pins 1 and 3 of
both sides of the connector when disconnected.
DO NOT REMOVE OR DISABLE THE AIRBAG
CONNECTOR SHORTING BAR UNDER ANY
CIRCUMSTANCES.
The airbag harness shorting bar may be temporarily
disabled during the following resistance checks.
Possible Causes
• Poorly mated airbag harness connector. If the
connector is poorly mated, the shorting bars
may not be fully retracted.
• Faulty shorting bar may short circuit 2-2 and 2-
3 together.
• A short across the airbag terminals in the
passengers airbag module.
Fault Analysis
1. Disarm the airbag system and check the security of
the passengers airbag module connector before
disconnecting.
If the connector is secure, complete the disarming
procedure, fit the airbag simulators (6.4.21.4). Go
to step 2
If the connector is insecure, service as necessary,
clear the code 35, rearm the airbags. Check that
code 35 does not recur.
2. Disconnectthediagnostic module and removethe
plastic wedge from connector 2 (black). Measure
the resistance between pins 2-2 and 2-3. The
resistance should be 2.4 - 2.6Q.
If the resistance is 2.4 - 2.6Q, go to step 4.
If the resistance is below 2.4 - 2.6fl, go to step 3.
3. Disconnect the airbag simulator at the passengers
airbag module and remove the plastic wedge from
the harness connector. Measure the resistance
between pins 2-2 and 2-3 at the diagnostic module
connector.
If the resistance is infinity, the airbag harness is
good at this time. Swap the airbag simulators at the
drivers and passengers airbag connectors. Repeat
the resistance check. If the resistance is less than
infinity, there is a fault in the passengers airbag
harness connector. Service the connector or replace
the harness as necessary. Refit the plastic wedges.
Reconnect the diagnostic module. Clear the code
35. Rearm the airbags.
If the resistance is less than infinity, service the
bulkhead harness as necessary. Refit the plastic
wedges. Reconnect the diagnostic module. Clear
the code 35. Rearm the airbags (6.4.21.4).
4. Since the circuit resistance is in specification, the
fault must lie in the diagnostic module or in the
airbag module.
Substitute a known good diagnostic module. If
code 35 recurs with the airbag simulator fitted,
there is still a fault in the wiring or the simulator.
If the fault code 35 does not recur, rearm the airbags
(6.4.21.4) and retest.
If fault code 35 recurs with the airbag module fitted,
the airbag module is faulty. Replace the passengers
airbag module (7.8.02.6).
6-94
September 1996