Airbag Dm Fault Code 34 - Aston Martin DB7 Workshop Manual

in:m3'^?
Electrics
Airbag System
Airbag DM Fault Code 34
Drivers airbag circuit low resistance or short circuit.
N o r m a l Operation
The diagnostic module measures the resistance
across pins 2-5 and 2-4 every time the ignition is
switched on. The resistance should be 1.6 to 1.8Q.
This value is made up of the airbag 1 .OQ and the
cable reel cassette windings 0.3-0.4£2 per winding.
If the total resistance in the passengers airbag
circuit falls below 0.7Q, fault code 34 will be
declared and the airbag lamp will be illuminated.
Note: The nominal resistance of the airbag simulator is
2.5Q, therefore expect a total circuit resistance readingof
3.1 - 3.3£2 with the simulator fitted.
Caution: The drivers airbag connector contains
shorting bars which short circuit pins 1 and 3 of
both sides of the connector when disconnected.
DO NOT REMOVE THE AIRBAC CONNECTOR
SHORTING BAR UNDER ANY CIRCUMSTANCES.
The airbag harness shorting bar may be temporarily
disabled during the following resistance checks.
Possible Causes
• Poorly mated cable reel cassette connector. If
the connector is poorly mated, the shorting bars
may not be fully retracted.
• Faulty shorting bar may short circuit 2-4 and 2-
5 together.
• Short circuit in the cable reel cassette windings.
• A short across the airbag terminals in the airbag
module.
Fault Analysis
Disarm the airbag system and fit airbag simulators
(6.4.21.4).
Disconnect the diagnostic module and remove the
plastic wedge from connector 2 (black). Measure
the resistance between pins 2-5 and 2-4. The
resistance should be 3.1 - 3.3Q.
If the resistance is 3.1 to 3.3Q, go to step 4.
If the resistance is below 3.1 - 3.3Q, go to step 3.
Disconnect the cable reel cassette connector at the
steering column and remove the plastic wedge.
Measure the resistance from pins 2-4 and 2-5 at the
diagnostic module connector.
If the resistance is infinity, check the cable reel
cassette for short circuits. Replace the column
switchgear assembly if necessary. Refit the plastic
wedges. Reconnect the diagnostic module. Clear
the code 34. Rearm the airbags (6.4.21.4).
If the resistance is less than infinity, replace the
main airbag harness. Refit the plastic wedges.
Reconnect the diagnostic module. Clear the code
34. Rearm the airbags (6.4.21.4).
Since the circuit resistance is in specification, the
fault must lie in the diagnostic module or in the
airbag module.
Substitute a known good diagnostic module. If
code 34 recurs with the airbag simulator fitted,
there is still a fault in the wiring or the simulator.
If the fault code 34 does not recur, rearm the airbags
(6.4.21.4) and retest.
If fault code 34 recurs with the airbag modulefitted,
the airbag module is faulty. Replace the drivers
airbag module (4.5.01.3).
September 1996
6-93