Lumbar Support Motor; Seat Recline Motor; Seat Control Unit; Door Edge Lamps - Aston Martin DB7 Workshop Manual

Electrics
Lumbar Support, Recline Motor and Seat Control Unit - Removal Procedures
6.6.06 Lumbar Support Motor
Procedure
1. Remove the seat from the car and remove the seat
back finisher panel.
2. Disconnect the lumbar motor plug and the lumbar
diaphragm air line (Fig 1) and remove the motor.
Figure /. Lumbar Support Motor Removal
6.6.07 Seat Recline Motor
6.6.08 Seat Control Unit
Procedure
1. Lift the footwell carpet, release the access plate
securing screws and remove the plate to gain
access to the seat control unit.
Figure 1. Seat Control Unit Removal
2. Disconnect the multiplug from the control unit.
3. Release the securing screws and remove the seat
control unit.
Procedure
1. Remove the seat from the car and remove the seat
back finisher panel.
2. Disconnect the recline motor connector.
Figure 1. Seat Recline Motor Removal
3. Disconnect the trigger cable from the motor.
4. Loosen two screws and remove the recline motor
from its bracket.
6.7.01 Door Edge Lamps
Procedure
1. Lever the lamp assembly from the door edge, taking
precautions to protect the door paintwork.
Figure 1. Door Edge Lamp Removal
2. Disconnect the lamp wiring and remove the door
edge lamp assembly.
6-12
May 1996