Bulb Replacement - BOMBARDIER rally 200 Operator's Manual

Fuse is located behind front right shock, near
coolant reservoir. Remove the cluster cover
to allow an access at the fuse holder.
1
V06G01Y
1. Fuse holder
To remove fuse from holder, unclip and re-
move holder cover then pull fuse out. Check
if filament is melted.
A15E0KY
1. Fuse
2. Check if melted

Bulb Replacement

Always check light operation after replace-
ment.
Headlamp
CAUTION: Never touch glass portion of an
halogen bulb with bare fingers, it shortens its
operating life. If glass is touched, clean it with
isopropyl alcohol which will not leave a film on
the bulb.
To unplug connector, release outer edge of
rubber protector from headlamp housing,
then pull on connector using a wiggle move-
ment.
NOTE: The rubber protector is a onepiece
component, encapsulating the connector.
1
VMO2006-001-008_a
1. Release outer edge of rubber protector
2. Pull on connector using a wiggle
2 movement
NOTE: Concerning the following illustrations,
the front facia has been removed from the ve-
hicle for a better comprehension.
Press the spindle then push it on the side to
unlock headlamp bulb.
107