Bulb Replacement
WARNING
Always turn the ignition switch OFF before
replacing a defective bulb.
Always check light operation after replace-
ment.
Headlamps
Each headlamp has two bulbs, one headlamp
bulb and one position lamp bulb.
CAUTION: Never touch glass portion of an
halogen bulb with bare fingers, it shortens its
operating life. If glass is touched, clean it with
isopropyl alcohol which will not leave a film
on the bulb.
To replace the headlamp bulb, proceed as fol-
lows.
NOTE: On the following illustration, the head-
lamp has been removed for a better compre-
hension.
Remove rubber holder screws.
TYPICAL
1. Screws
2. Rubber holder
Remove rubber protector over headlamp
housing.
TYPICAL
1. Rubber protector
2. Headlamp housing
Unplug connector from headlamp.
NOTE: Use small locking tab to unlock con-
nector then pull on connector.
PUSH ON LOCKING TAB TO UNLOCK
CONNECTOR
NOTE: Concerning the following illustrations,
the front fascia has been removed from the
vehicle for a better comprehension.
Press the spindle then push it on the side to
unlock headlamp bulb.
137