Table of Contents
Advertisement
NOTE: Throttle assist may be used to help
engine starting faster. Press the throttle lever
slightly. If too much throttle is used the choke
system will not be activated.
Release start button immediately when en-
gine has started.
After a few seconds, move the choke lever
from full choke position to an intermediate po-
sition until the best engine RPM is achieved.
NOTE: Overusing choke may flood engine
and make it hard to start. Refer to SPECIAL
PROCEDURES if it occurs.
When the engine is warm, push the choke le-
ver to OFF and release brakes.
Warm Engine Starting
Start the engine as explained above but with-
out the choke. If the engine does not start af-
ter two 5-second attempts with the electric
starter, move the choke lever and place it half
way position. Start the engine without activat-
ing the throttle lever. After a few seconds,
push the choke lever to OFF.
Stopping the Engine
WARNING
Avoid parking vehicle on slope.
Release throttle and completely stop the ve-
hicle.
Apply the parking brake by using brake lever
lock on brake lever.
Set transmission lever in NEUTRAL position.
Push the engine stop switch in OFF position.
Turn key in ignition switch to OFF.
Remove key from ignition switch.
Shifting the Transmission
Let engine idle to warm up.
Apply brakes and select the desired gear
range H.
Release brakes.
CAUTION: Make sure parking brake is fully
disengaged before operating the ATV.
Gradually press the throttle lever to increase
engine speed add thus engaging the continu-
ously variable transmission (CVT).
At the opposite, when the throttle lever is re-
leased, the engine speed decreases.
Using the Reverse
CAUTION: When changing from forward to
reverse, or vice-versa, always completely
stop the vehicle and apply the brake prior to
moving the transmission lever.
The same procedures as SHIFTING THE
TRANSMISSION above apply except for the
following.
Set the transmission lever in REVERSE posi-
tion.
81
Hide quick links:
Advertisement
Table of Contents
