Oil Pressure Regulator - BOMBARDIER rally 200 Operator's Manual

Reinstall oil strainer plug with a new gasket.
Change gasket on drain plug. Clean gasket
area on engine and drain plug, then reinstall
plug.
Refill engine at the proper level with the rec-
ommended oil. Refer to SPECIFICATIONS
for capacity.
Start engine and let idle for a few minutes. En-
sure oil filter area and drain plug areas are not
leaking;
Stop engine. Wait a while to allow oil to flow
down to crankcase then check oil level. Refill
as necessary.
Dispose of oil as per your local environmental
regulations.

Oil Pressure Regulator

When changing engine oil at each 50 hours,
the oil pressure regulator must be removed
and cleaned.
The oil pressure regulator is located on the
left side of the engine, near the cooling drain
plug.
2
V06C2FY
1. Cooling drain plug
2. Oil pressure regulator plug
Clean plug area then remove it.
Remove valve housing, compression spring
and ball.
R175motr135Y
1. Valve holding
2. Compression spring
3. Ball
4. Oil pressure valve port
NOTE: Oil coming out will push out spring
loaded ball; take care not to lose spring and
ball.
Clean all parts and oil pressure regulator port.
Check compression spring's free length. If the
length of the spring is less than 13.2 mm
(0.519 in), replace it by a new one.
Install all removed parts and torque the plug
to 30 N·m (22 lbf·ft).
1
4 3 2 1
99