Bulb Replacement - BOMBARDIER outlander max 800 Operator's Manual

REAR — FUSES LOCATION
1. (F8) Main (30 A)
(F9) Main accessories (30 A)
To remove fuse from holder, remove the fuse
holder cover then pull fuse out. Check if fila-
ment is melted.
A15E0KY
TYPICAL
1. Fuse
2. Check if melted

Bulb Replacement

Always turn the ignition switch OFF before
replacing a defective bulb.
Always check light operation after replace-
ment.
Headlamps
CAUTION: Never touch glass portion of an
halogen bulb with bare fingers, it shortens its
operating life. If glass is touched, clean it with
isopropyl alcohol which will not leave a film on
the bulb.
Remove cover screws.
1
2
1. Screws
2. Cover
Remove rubber protector over headlamp
housing.
1. Rubber protector
2. Headlamp housing
WARNING
135