Fuses; Bulb Replacement - BOMBARDIER Outlander 400 Operator's Manual

WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.

Fuses

If a fuse is damaged, replace it by one
of the same rating.
CAUTION: Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuses are located in the service com-
partment, behind tool kit.
V07C0IY
TYPICAL
1. Fuse holders
vmo2006-005-029_a
1. Accessories (15 A) (power outlet and
auxiliary supply)
2. Fan (20 A)
3. Main (30 A)
4. Charging system (20 A)
_____________________
116
1
To remove fuse from holder, remove
the fuse holder cover then pull fuse
out. Check if filament is melted.
A15E0KY
TYPICAL
1. Fuse
2. Check if melted

Bulb Replacement

WARNING
Always turn the ignition switch
OFF before replacing a defective
bulb.
Always check light operation after re-
placement.
Headlamps
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
Remove holder screws.
1
2