Wheel; Wheel Bearing/Bushings Condition; Tires/Wheels - BOMBARDIER rally 200 Operator's Manual

CAUTION: Replace chain, sprocket axle and
pinion together to prevent rapid chain and
sprocket wear. Install a new retaining ring
each time the pinion is removed.
NOTE: The drive pinion must be installed with
the lip toward the outside of vehicle.

Wheel

Occasionally, wheel nuts should be removed
to apply anti-seize lubricant on studs to ease
future removal. This is particularly important
when vehicle is used in salt-water environ-
ment or in mud. Remove one nut at a time,
lubricate then retorque to 70 N·m (52 lbf·ft).
Wheel Bearing/Bushings
Condition
Push and pull the wheels from the upper edge
t o f e e l t h e p l a y. S e e a n a u t h o r i z e d
Bombardier ATV dealer if there is any play.
V06I0SY

Tires/Wheels

Tire Pressure
WARNING
Tire pressure greatly affects vehicle han-
dling and stability. Underpressure may
cause tire to deflate and rotate on wheel.
Overpressure may burst the tire. Always
follow recommended pressure. Since tires
are low-pressure types, a manual pump
should be used.
Check pressure when tires are COLD before
using the vehicle. Tire pressure changes with
temperature and altitude. Recheck pressure
if one of these conditions has changed.
For your convenience, a pressure gauge is
supplied in tool box.
TIRE PRESSURE
RECOMMENDED
MINIMUM
Although the tires are specifically designed
for off-road use, a flat may still occur. There-
fore, it is recommended to carry a tire pump
and a repair kit.
FRONT REAR
35 kPa (5 PSI)
21 kPa (3 PSI)
111