Bulb Replacement - BOMBARDIER Outlander 400 Operator's Manual

Bulb Replacement

WARNING
Always turn the ignition switch OFF before
replacing a defective bulb.
Always check light operation after replace-
ment.
Headlamps
CAUTION: Never touch glass portion of an
halogen bulb with bare fingers, it shortens its
operating life. If glass is touched, clean it with
isopropyl alcohol which will not leave a film on
the bulb.
To replace the headlamp bulb, proceed as fol-
lows.
NOTE: On the following illustration, the head-
lamp has been removed for a better comprehen-
sion.
Remove rubber holder screws.
TYPICAL
1. Screws
2. Holder
Remove rubber protector over headlamp
housing.
1. Rubber protector
2. Headlamp housing
114
Unplug connector from headlamp.
NOTE: Use small locking tab to unlock connec-
tor then pull on connector.
PUSH ON LOCKING TAB TO UNLOCK
CONNECTOR
NOTE: Concerning the following illustrations,
the front fascia has been removed from the ve-
hicle for a better comprehension.
Press the spindle then push it on the side to
unlock headlamp bulb.
V06G0RY
TYPICAL
Lift and hold the spindle then remove the bulb.