WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.
Fuse
If fuses are damaged, replace them by
one of the same rating.
CAUTION: Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuses are located underneath the seat
in the service compartment. Remove
the seat to allow an access at the fuse
holder.
vmo2006-014-047_a
1. Fuse holder
To remove fuse from holder, unclip
and remove holder cover then pull
fuse out. Check if filament is melted.
_____________________
112
1. Fuse
2. Check if melted
Bulb Replacement
Always check light operation after re-
placement.
Headlamp
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
To unplug connector, remove rubber
protector from headlamp housing,
then pull on connector using a wiggle
movement.
vmo2006-014-057_a
1. Remove rubber protector
2. Pull on connector using a wiggle movement
Unlock bulb holder by turning it coun-
terclockwise.