Table of Contents
Advertisement
To remove fuse from holder, remove the fuse
holder cover then pull fuse out. Check if fila-
ment is melted.
A15E0KY
TYPICAL
1. Fuse
2. Check if melted
Bulb Replacement
WARNING
Always turn the ignition switch OFF before
replacing a defective bulb.
Always check light operation after replace-
ment.
Headlamps
Each headlamp has two bulbs, one headlamp
bulb and one position lamp bulb.
CAUTION: Never touch glass portion of an
halogen bulb with bare fingers, it shortens its
operating life. If glass is touched, clean it with
isopropyl alcohol which will not leave a film
on the bulb.
To replace the headlamp bulb, proceed as fol-
lows.
NOTE: On the following illustration, the head-
lamp has been removed for a better compre-
hension.
Remove rubber holder screws.
1
2
TYPICAL
1. Screws
2. Rubber holder
Remove rubber protector over headlamp
housing.
TYPICAL
1. Rubber protector
2. Headlamp housing
109
- Quick Links:
- Engine/Transmission Oil
Hide quick links:
Advertisement
Table of Contents
