Drive Train; Lubrication; Drive Chain - BOMBARDIER rally 200 Operator's Manual

DRIVE TRAIN

Lubrication

Lubricate front knuckles. Use synthetic
grease (P/N 293 550 033) or an equivalent.
There is a grease fitting on each knuckle.
V06H01Y

Drive Chain

Adjust and lubricate the drive chain before
each use.
WARNING
Place ignition switch to OFF before you
checking, adjusting or lubricating the drive
chain.
CAUTION: Never operate this vehicle with
the drive chain too loose or too tight as severe
damage to the drive components can occur.
Inspection
This ATV is equipped with O-ring sealed per-
manently greased pins and rollers. Before op-
erating the vehicle, always inspect the drive
chain.
Check the free play of drive chain and adjust
if necessary.
Check for damage or missing O-ring or roll-
ers.
Lubrication and Cleaning
CAUTION: Never wash the chain with a high
pressure washer or gasoline. Damage to the
O-ring will result, causing premature wear
and drive chain failure.
Clean the side surfaces of the chain with a dry
cloth.
NOTE: Do not brush chain.
Lubricate only with an approved O-ring chain
lubricant. Other commercial chain lubricants
may contain solvent which could damage the
O-rings.
Adjustment
NOTE: Never adjust drive chain with the driv-
er seated on the vehicle. Remove all load on
vehicle.
Select a level surface and set transmission to
NEUTRAL.
Loosen chain tensioner lock bolts.
V06H0QY
1. Chain tensioner lock bolts
1
109