Assembling The Splash Guard Rubbers (Bases With Disc Brushes) - COMAC SIMPLA 55BT Use And Maintenance Manual

ATTENTION: always use detergents whose manufacturer's label indicates
their suitability for scrubbing machines. Do not use acid or alkaline products or
solvents without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids or detergents with a stronger gradation than that
indicated on the label supplied.
ATTENTION: you are advised to always wear protective gloves in order to
avoid the risk of serious injury to your hands
ATTENTION: the metering system is particularly suitable for frequent
maintenance cleaning.
Acid or alkaline detergents can be used with pH values between 4 and 10 and
that do not contain: oxidising agents, chlorine or bromine, formaldehyde, mineral
solvents.
The detergents used must be suitable for use with scrubbing machines.
If the system is not use on a daily basis, wash the circuit with water after use. The
system can be excluded. In the case of occasional use of detergents with a pH of
1-3 or 11-14, use the scrubbing machine in the traditional way by adding the
detergent in the water clean tank and excluding the metering circuit (see
paragraph 25 for the procedure).
21.

ASSEMBLING THE SPLASH GUARD RUBBERS (BASES WITH DISC BRUSHES)

For packaging reasons, the splash guard rubbers are supplied disassembled from the machine. To
connect the rubber, remove the rubber-pressing blades and unthread the spring hook (1) from the
connection screw. Wind the rubber all around the base, inserting the base fixing screw in the central
hole. Reattach the blades, starting from the centre of the base.
Be careful not to invert the right blade with the left one, as they are not the same.
MACHINE PREPARATION
17
1