How To Move The Machine; Instrument Panel Components; Rear Components - COMAC SIMPLA 55BT Use And Maintenance Manual

3. HOW TO MOVE THE MACHINE

1. To safely transport the machine, the pallet should be used to support the machine, using a chute to
position the machine on the pallet and secure the wheels using the wooden wedges, as shown in
the previous paragraph.
2. Lower the squeegee (1) by means of the lever or the key (AU version).
3. Use the lever or key (AU version) to lower the base (2) until the brushes are resting on the floor.
4. Pull the brake lever (3) and block the machine using the pin (4).

4. INSTRUMENT PANEL COMPONENTS

The instrument panel components are identified as follows:
1- levers to activate brushes/traction (located beneath the grip)
2- Water outlet regulation switch (CDS versions)
3- Detergent outlet regulation switch (CDS versions)
5- automatic squeegee command lever (automatic version)
6- Automatic base command lever (automatic version)
7- battery level / hour-counter display
8- command button for the monitor of the hour-counter battery level
9- speed level key

5. REAR COMPONENTS

The rear components are identified as follows:
1- pedal to raise the brushes
2- water level tube
3- solution filter
4- drainage tube with recovery tank cap
5- Hinges to close the tanks
6- screws to fix the handlebars
7- lever to raise the squeegee (manual version only)
8- brake lever
9- solution tank drainage cap
10- key and trip unit switch
MACHINE PREPARATION
9
1 2
4
3
8 2 7
5 3 6
8
4
7
2
9 3
9
1
5
6
10
1