1. CLEANING THE RECOVERY TANK
1. Engage the parking brake and turn the main switch to "0"
2. Raise the suction cover and keep it still using the lifting rod (1) at the side.
3. Remove the drainage tube (2) from its seat.
4. Remove the cap and empty the tank.
5. Rinse the inside of the tank well with a jet of water.
6. Reposition the cover on the machine and replace the drainage hose cap.
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
2. CLEANING THE SUCTION FILTER
1. Engage the parking brake and turn the key switch to position "0 "
2. Check the recovery tank is empty (if necessary, empty it).
3. Raise the cover (1), blocking its stroke with the clamp (2)
4. Remove the suction filter protection (3) by rotating it clockwise
5. Remove the suction filter (4) from its seat
6. Use a jet of water to clean the walls and base of the filter
7. reassemble all the elements
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
3. CLEANING THE SUCTION TUBE FILTER
1. Engage the parking brake and turn the key switch to position "0 "
2. Check the recovery tank is empty (if necessary, empty it).
3. Raise the suction cover and block it as indicated in the previous paragraph
4. Rotate the inner filter (1) and remove it
5. Carry out the cleaning operations carefully
6. reassemble all the elements
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
DAILY MAINTENANCE
PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
25
1
2
1
4
2
1