1. CLEANING THE SQUEEGEE TUBE
Every week, or whenever suction seems to be unsatisfactory, check the squeegee tube is not obstructed.
To clean it, proceed as follows:
1. Engage the parking brake and turn the key switch to position "0 "
2. Check the recovery tank is empty (if necessary, empty it).
3. remove the tube from the sleeve on the squeegee
4. open the recovery tank
5. remove the other end of the tube (2) from the rubber-holder connector (3) of the recovery tank
6. wash the inside of the tube with a jet of water (from the tank side)
7. reassemble the tube
2.
CHECKING THE WHEEL BRAKE
Every week, check the distance between the work brake pads and the wheels. If necessary, adjust them
by means of the nuts, so they are at a distance of 3mm when homed.
3.
CLEANING THE SOLUTION TANK
1. Engage the parking brake and turn the key switch to position "0 "
2. Loosen the front cap of the solution tank
3. Loosen the wing nut of the drainage cap (1) to the left of the tank, and remove the cap
4. Rinse the inside of the tank with a jet of water
5. Insert the cap in the tank, and retighten the wing nut (1)
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
WEEKLY MAINTENANCE
28
3
2
1