Detergent Solution ( Version Without Cds ); Solution Tank / Detergent Tank (For Systems With Cds Only) - COMAC SIMPLA 55BT Use And Maintenance Manual

19.

DETERGENT SOLUTION ( VERSION WITHOUT CDS ).

1. Check the switch key is on "0".
2. Apply the parking brake by pulling the lever and blocking the handle with the pin.
3. Make sure the recovery tank is empty before opening, if full empty it.
4. Remove the front filler cap.
5. Fill with clean water at a temperature not exceeding 50° C, the amount present in the tank can be
seen through the level pipe (1) on the back of the machine.
The solution tank has a maximum capacity of about 55 litres. Add the liquid detergent to the tank in the
concentration and manner indicated on the detergent manufacturer's label. The formation of excess
foam could damage the suction motor, so use only the minimum amount of detergent necessary.
ATTENTION: always use detergents whose manufacturer's label indicates
their suitability for scrubbing machines. Do not use acid or alkaline products or
solvents without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids
ATTENTION: you are advised to always wear protective gloves, to avoid the
risk of serious injury to your hands
20.

SOLUTION TANK / DETERGENT TANK (FOR SYSTEMS WITH CDS ONLY).

1. Check the switch key is on "0".
2. Apply the parking brake by pulling the lever and blocking the handle with the pin.
3. Make sure the recovery tank is empty before opening, if full empty it.
4. Release the hinges (1) on the handlebars.
5. Rotate the recovery tank as far as it will go, using the side handle (2).
6. Unscrew the cap (3) of the canister in the compartment (behind the batteries) and fill it with liquid
detergent in the manner indicated on the label supplied with the machine.
7. Check the screw cap is well closed, to avoid any liquid leaking out while the machine is being
used.
8. Close the recovery tank, rotating it by hand. Only hold the recovery tank by the handle (2), to
avoid crushing your hands.
9. Unscrew the front cap of the solution tank and fill with clean water at a temperature of not
more than 50°C. To regulate the water/detergent mixture, carefully read the "REGULATING
THE DETERGENT WITH THE CDS SYSTEM" paragraph.
MACHINE PREPARATION
16
1
1
3
2