Choosing And Using The Brushes - COMAC SIMPLA 55BT Use And Maintenance Manual

Use and maintenance manual (36 pages)

Use and maintenance manual (16 pages)

Daily maintenance (2 pages)

Table of Contents

POLYPROPYLENE BRUSH (PPL)

Used on all types of floors. Good resistance to wear and tear, and hot water (no greater than 60°C). The Polypropylene brush is non-hygroscopic and

therefore retains its characteristics even when working in wet conditions.

ABRASIVE BRUSH

The bristles of this type of brush are charged with highly aggressive abrasives. It is used to clean very dirty floors. To avoid floor damage, work only with the

pressure strictly necessary.

THICKNESS OF THE BRISTLES

Thicker bristles are more rigid and are therefore used on smooth floors or floors with small joints.

On uneven floors or those with deep joints, it is advisable to use softer bristles which can enter the gaps more easily.

Remember that when the bristles are worn and therefore too short, they will become rigid and are no longer able to penetrate and clean deep down. In this

case, like with over-large bristles, the brush tends to jump.

PAD HOLDER

The pad holder is recommended for cleaning shiny surfaces.

There are two types of pad holder:

1. the traditional pad holder is fitted with a series of anchor points that allow the abrasive floor pad to be held and dragged while working

2. the CENTRE LOCK type pad holder not only has anchor points, but also a snap-type central locking system in plastic that allows the abrasive floor pad

to be perfectly centred and held without any risk of it becoming detached. This type of dragging device is recommended above all for machines with

more than one brush, where the centring of the abrasive discs is difficult

TABLE FOR CHOOSING THE BRUSHES

Machine

No. Brushes

SIMPLA 55BT

SIMPLA 65BT

SIMPLA 50SBT