At The End Of The Work; Emptying The Mx Hopper - COMAC SIMPLA 55BT Use And Maintenance Manual

1. AT THE END OF THE WORK

At the end of the work, and before carrying out any type of maintenance:
1. raise the base by means of the pedal (2) or the key (6) (automatic version)
3. Raise the squeegee by means of the lever (3) or the key (4) (automatic version). When the squeegee
is up, the suction motor switches off automatically
4. bring the machine to the place provided for draining the water
5. turn the key switch (5) anticlockwise (to "OFF") to switch off the machine
6. pull the brake lever and block it with the pin (7)
7. Remove the drainage hose (8) from its compartment, unscrew the drainage cap (9) and empty the
recovery tank
8. the squeegee must be raised when the machine is not operating in order to avoid deforming the
rubber blades
9. disassemble the brushes and clean them with a jet of water (to disassemble the brushes, see
"DISASSEMBLING THE BRUSHES" below)

2. EMPTYING THE MX HOPPER

Empty the hopper after work and before performing any type of maintenance, to do so proceed as follows:
1. Push the knob (1) towards the rear of the machine and release the left side splash guard.
2. Extract the hopper, empty and clean it thoroughly
3. reassemble all the elements.
4. Raise the brushing unit at the end of the work, to avoid deforming the brushes.
WARNING: this operation must be carried out wearing gloves to protect against
contact with dangerous solutions.
AT THE END OF THE WORK
23
4
5
3
2
7
9
8
1
6