Connection Of The Electrical Power Supply Connector (For Versions B-Bt Only) - COMAC SIMPLA 55BT Use And Maintenance Manual

To charge the battery proceed as follows:
1. Engage the parking brake.
2. Check that the machine's master switch is in the "0" position.
3. Lower the base by means of the pedal on the back of the machine
4. Lower the squeegee by means of the lever on the back of the machine.
5. Check the recovery tank is empty, otherwise empty it (see the appropriate chapter).
6. release the hinges (1) on the handlebars
7. Rotate the tank as far as it will go, using the side handle (2)
8. Attach the battery charger connector to the battery connector.
Allow the battery to charge until the green LED of the charger lights
ATTENTION: Carefully read the use and maintenance instructions of the
battery charger that is used for charging.
ATTENTION: Keep the recovery tank open for the duration of the battery
recharging
to allow gas fumes to escape
11. CONNECTION OF THE ELECTRICAL POWER SUPPLY CONNECTOR (FOR VERSIONS B-
BT ONLY)
Proceed as follows to connect the machine connector to the battery connector:
1. Engage the parking brake.
2. Check that the machine's master switch is in the "0" position.
3. Lower the base by means of the pedal on the back of the machine
4. Lower the squeegee by means of the lever on the back of the machine.
5. Check the recovery tank is empty, otherwise empty it (see the appropriate chapter).
6. release the hinges (1) on the handlebars
7. Rotate the tank as far as it will go, using the side handle (2)
Make sure the main switch is disconnected (the key must be set to "0 ").
8. Connect the machine connector (1) to the battery connector (2)
9. Close the recovery tank, always using the side handle to avoid crushing hands.
10. Close the hinge located on the handlebars, lift the base and the squeegee.
ATTENTION: this is done only once for machines with built-in battery charger,
with the exception of maintenance operations
MACHINE PREPARATION
12
1
cycle
1
2
2