1. INSUFFICIENT WATER ON THE BRUSH
1. Check the tap beneath the symbol (1) is turned on.
2. Check there is water in the solution tank.
3. Check that the solution tank filter cartridge is not obstructed
2. THE MACHINE DOES NOT CLEAN WELL
1. Check the state of wear and tear of the brush and, if necessary, replace it (the brush must be replaced
when the bristles are about 15 mm long).
2. Use a different kind of brush to the one fitted as standard. For cleaning floors where the dirt is
particularly resistant, we recommend the use of special brushes supplied upon request and according
to needs (see "CHOOSING AND USING THE BRUSHES").
3. THE SQUEEGEE DOES NOT DRY PERFECTLY
1. Check the squeegee rubbers are clean.
2. Adjust the inclination and height of the squeegee (see the "ADJUSTING THE SQUEEGEE
INCLINATION AND HEIGHT" paragraph).
3. Check the suction tube is correctly inserted in its housing on the recovery tank.
4. Check the inner filter of the recovery tank is not dirty and, if necessary, clean it thoroughly.
4. EXCESSIVE FOAM PRODUCTION
Check that a low foam detergent has been used. If necessary, add a small quantity of antifoam liquid to the
recovery tank.
Remember that, when the floor is not very dirty, more foam is generated. In this case the detergent
solution should be more diluted.
TROUBLESHOOTING
30
1