6. SIDE COMPONENTS
The side components are identified as follows:
1- Water solution inlet cap
2- handle to raise the recovery tank
3- handle to raise the suction unit
A
7. TYPE OF BATTERY
To power the machine it is necessary to use:
•
liquidelectrolyte lead traction batteries
•
sealed traction batteries with gasrecombination or gel technology
OTHER TYPES MUST NOT BE USED.
The batteries must meet the requisites laid out in standards CEI EN 60254-1:2005-12 (CEI 21-5) + CEI
EN 60254-2:2008-06 (CEI 21-7).
Every battery consists of DIN-type elements connected in series and supplying 6V power to the
clamps. You are advised to use batteries with an electric capacity of 120 Ah (C5).
8. BATTERY MAINTENANCE AND DISPOSAL
For maintenance and recharging, respect the instructions provided by the battery manufacturer.
Particular attention must be paid when choosing the battery charger, if not supplied, since there are
different kinds according to the type and capacity of the battery.
When the battery reaches the end of its working life, it must be disconnected by expert, trained
personnel, then lifted (using the grips and suitable lifting devices) to remove it from the battery
compartment. EXHAUSTED BATTERIES ARE CLASSIFIED AS DANGEROUS WASTE AND MUST
BE CONSIGNED TO THE AUTHORISED BODIES FOR CORRECT DISPOSAL.
ATTENTION: you are advised to always wear protective gloves, to avoid the
risk of serious injury to your hands
ATTENTION: You are advised to only lift and move the batteries with lifting
and transportation means suitable for the specific weight and size
MACHINE PREPARATION
10
3
2
1