Table of Contents
Advertisement
3. Connections
3.5.4 Computer input/Monitor output
How to connect the computer to the input?
1. Connect the output of the graphical card of the computer to the Computer input of the projector
Note: Only if the connection is < 60 cm. Otherwise insert an interface between the output of the computer and the input of the
projector.
2. Connect the monitor of the computer to the monitor output of the projector. This monitor output is only available when the com-
puter input is used as input.
Pin configuration of the D15 connector.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
How to select slot 2.
1. Key in 2 on the RCU or local keypad.
3.5.5 Video input
What can be connected to the Video input?
Composite video signals from a VCR, OFF air signal decoder, etc... No loop through.
22
Downloaded From projector-manual.com Barco Manuals
RED
GREEN
BLUE
loop through to monitor
ground
ground
ground
ground
loop through to monitor
ground
loop through to monitor
loop through to monitor
horizontal/composite sync
vertical sync
loop through to monitor
Video
Composite Video is a single video signal that contains luminance, color and synchronization information. NTSC, PAL
and SECAM are examples of composite video systems.
R5976182 BARCOREALITY 6500 30012001
Advertisement
Chapters
Table of Contents
