Start Up With Identification Screen; Start Up Auto Power; Network Configuration - Barco BARCOREALITY 6500 Owner's Manual

8.8.1 Start up with identification screen

How to set up?
1. Push the cursor key ↑ or ↓ to highlight Start Up Mode. (menu 8-18)
2. Press ENTER to display the start up mode menu. (menu 8-19)
3. Push the cursor key ↑ or ↓ to highlight Identification.
4. Press ENTER to toggle between [ON] or [OFF].
[ON]
[OFF]
INSTALLATION
INPUT SLOTS
NO SIGNAL
TEXT BOX POSITION
QUICK ACCESS KEYS
START UP MODE

NETWORK CONFIGURATION

more ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-18

8.8.2 Start up auto power

Set up the auto power mode.
1. Push the cursor key ↑ or ↓ to highlight Start Up Mode. (menu 8-20)
2. Press ENTER to display the start up mode menu. (menu 8-21)
3. Push the cursor key ↑ or ↓ to highlight Auto Power.
4. Press ENTER to toggle between [ON] or [OFF].
[ON]
[OFF]
INSTALLATION
INPUT SLOTS
NO SIGNAL
TEXT BOX POSITION
QUICK ACCESS KEYS
START UP MODE
NETWORK CONFIGURATION
more ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-20
8.9 Network Configuration
What can be done?
The necessary network addresses (configuration) can be entered so that the projector can be connected to a LAN (local area ne
R5976182 BARCOREALITY 6500 30012001
Downloaded From projector-manual.com Barco Manuals
projector identification will be displayed during start up.
a blank screen will be displayed during start up
START UP MODE
IDENTIFICATION : [ON]
AUTO POWER : [ON]
LENS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-19
projector starts up as it was switched off before. When the projector was in standby before it was switched
off, it starts up in standby. When it was switched off with full power, it starts up with full power.
projector always starts up in standby mode.
START UP MODE
IDENTIFICATION : [ON]
AUTO POWER : [ON]
LENS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-21
DHCP
Dynamic host configuration protocol
8. Installation mode
71