Table of Contents
Advertisement
Possible indication :
RGB [HS&VS] = RGB analog signals, separate sync is horizontal and vertical sync.
RGB CS = RGB analog signals, separate sync is composite sync.
RGB CV = RGB analog signals, separate sync is composite video or tri-level sync.
RGB-SOG = RGB analog signals, sync on green is composite sync.
COMPONENT VIDEO - CS = separate sync is composite sync.
COMPONENT VIDEO = component video with composite sync on Y or composite tri-level sync on Y.
VIDEO
S-VIDEO
Note for RCVDS05 users
When using an RCVDS 05 with a 5 cable output module, connect these 5 cables to this 5-cable input slot (slot1) of the projector.
All sources of the RCVDS can now be accepted by the projector.
Audio connection
Connect the audio input to one of the 3 audio inputs.
See 'audio configuration' in this chapter for more explanation.
Computer input/Monitor output
Connect the output of the graphical card of the computer to the Computer input of the projector (connection < 60 cm) or insert an
interface between the output of the computer and the input of the projector.
Connect the monitor of the computer to the monitor output of the projector.
This monitor output is only available when the computer input is used as input.
3
VIDEO
R
G
Pin configuration of the D15 connector :
1
2
3
4
5
6
7
5976183 BARCOGRAPHICS 6500 31012001
4
6
S-V IDEO
SDI
5
IEEE 1394
M OUSE
SDO
2
M ONITO R
B
H/C
V
1
COM PUTER
8
RED
9
GREEN
10 ground
BLUE
11 loop through to monitor
loop through to monitor
12 loop through to monitor
ground
13 horizontal/composite sync
ground
14 vertical sync
ground
15 loop through to monitor
RS232 IN
RS232 O UT
COM M. PORT
10/10 0BASE-T
AUDIO IN
A
AUDIO IN
B
AUDIO IN
ground
loop through to monitor
RC
C
A UDIO IN
Connections
4-5
Advertisement
Table of Contents
