Table of Contents
Advertisement
3.3 Switching to standby.
How to switch to standby?
1. Press STANDBY for 2 seconds until the messages Saving data please wait is displayed. (image 4-5)
Note: Do not press any longer on the STANDBY key otherwise the projector will restart.
Image 3-4
3.4 Switching off
How to switch off the projector?
To switch off the projector, handle as follow :
1. Press STANDBY key for 2 seconds. When the message Saving data, please wait is displayed, do not press any longer on the
STANDBY key otherwise the projector will restart.
Warning:
2. Switch off the projector with the power switch.
3.5 Input Source connection
3.5.1 Input facilities
Overview input facilities
•
5-cable input
•
Computer
•
Video
•
S-Video
•
Serial digital input
•
IEEE 1394 input (optional)
Input selection
This can be manually or automatically.
When 'automatic' is selected in the Input slots menu, by starting up the projector, it searches for an input source by scanning the
inputs one by one. If only one source is found, this source will be projected. If different sources are found, the priority is as follow
1.
Video
2.
S-Video
3.
5 cable input
4.
Computer input
R5976182 BARCOREALITY 6500 30012001
Downloaded From projector-manual.com Barco Manuals
When switching to standby, it is possible to restart within the first 5sec.. When not restarted within these first
5 sec., the projector waits for 1 min. to restart again. During this period the LED display will show a jumping
square with a dash. After one minute, two dashes will be displayed and the projector can restart.
Let cool down the projector at least 10 min.
SDI and IEEE input are never automatically selected.
When a RCVDS is connected to the projector, the 'Automatic' selection is disabled.
3. Connections
19
Advertisement
Chapters
Table of Contents
