Table of Contents
Advertisement
Possible indication:
RGB [HS&VS]
RGB CS
RGB CV
RGB-SOG
COMPONENT VIDEO - CS
COMPONENT VIDEO
VIDEO
S-VIDEO
When using an RCVDS 05 with a 5 cable output module, connect these 5 cables
to this 5-cable input slot (slot1) of the projector.
All sources of the RCVDS can now be accepted by the projector.
5.1.11 Computer input/Monitor outp ut
! Connect the output of the graphical card of the computer to the
(connection < 60 cm) or insert an interface between the output of the computer and the input of
the projector.
! Connect the monitor of the computer to the monitor output of the projector.
! This monitor output is only available when the computer input is used as input.
Pin configuration of the D15 connector:
1
RED
2
GREEN
3
BLUE
4
loop through to monitor
5
ground
6
ground
7
ground
8
ground
Slot 2 selection:
! Press the digit button
R5976255 A
CS4 (2001-03)
TLAS
RGB analog signals, separate sync is horizontal and vertical
sync.
RGB analog signals, separate sync is composite sync.
RGB analog signals, separate sync is composite video or tri-
level sync.
RGB analog signals, sync on green is composite sync.
separate sync is composite sync.
component video with composite sync on Y or composite tri-
level sync on Y.
9
10
11
12
13
14
15
on the
or the local
2
RCU
computer input
loop through to monitor
ground
loop through to monitor
loop through to monitor
sync horizontal / composite
sync vertical
loop through to monitor
.
keypad
of the projector
5-12
Advertisement
Table of Contents
