Ieee 1394 Input; Communication Connections; Ieee Connection To The Projector - Barco BARCOREALITY 6500 Owner's Manual

3. Connections
How to connect a SDI source ?
1. Connect the out of your SDI source to the BNC SDI input of the projector.
Note: The input is always 70 ohm terminated.
2. If loop through is needed, use the SDO output to connect to next device.
Note: The output impedance of the SDO is 75 ohm.
How to select slot 5
1. Key in 5 on the RCU or the local keypad.

3.5.8 IEEE 1394 input

What can be connected ?
This input allows to display video in DV format on the 1394 bus (also called Firewire
camera mode or in VCR mode, playing a tape, it will broadcast the compressed video and audio on the 1394 bus.
How to connect ?
1. Connect the output of your DV source to the IEEE 1394 input of the projector. (image 3-7)
Image 3-7

IEEE connection to the projector

How to select slot 6?
1. Key in 6 on the RCU or the local keypad.
Note: When slot 6 is selected, the projector will automatically detect the presence of video on the bus and display it. If not,
the 1394 setup command in the Random access adjustment mode can be used to start the decoding manually (only for
sources that not fully implement the AV/C protocol).

3.6 Communication connections

Overview
• RS232
• Communication with peripherals
• Mouse
• Network Connection
24
Downloaded From projector-manual.com Barco Manuals
When a RCVDS05 is connected to the projector, the SDI input is available by keying in 85 on the RCU.
DV format
Digital Video format
TM or i.Link TM ). When a DV camcorder is in
R5976182 BARCOREALITY 6500 30012001