Rcu Function Indication - Barco BARCOREALITY 6500 Owner's Manual

4. Getting Started
Image 4-1

RCU function indication

1 Function keys
2 ADJ.
3 Address key
4 Selection key (*)
5 PAUSE
6 STBY
7 MUTE
8 ?
9 Digit buttons
10 Audio controls
11 Picture controls
12 Phase
13 FREEZ
28
Downloaded From projector-manual.com Barco Manuals
user programmable keys with functions for direct access.
Adjust key, to enter the adjustment mode
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
to direct access the zoom/focus/shift functions.
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds until the message 'Saving data,
please wait' is displayed. Do not press any longer on the standby key otherwise
the projector will restart.
to interrupt the sound reproduction.
Auto image, to center the image on the active LCD surface.
direct input selection.
use these buttons to obtain the desired sound level.
press to adjust the projected image.
press to adjust the phase of the projected image.
press to freeze the projected image.
R5976182 BARCOREALITY 6500 30012001