Led Indicators - ATTO Technology FibreBridge 2370E Installation And Operation Manual

LED indicators

The LED indicators can be viewed from the connector
side and the front side of the FibreBridge 2400R/D.
(See Exhibit 1.4-1)
LEDs on the connector side are:
A bicolor Ready/Fault LED lights green to indicate
ready, lights yellow to show a faulted condition,
and is off to indicate not ready.
Embedded in the Ethernet port connector: a
lighted green LED shows a valid link; off indicates that
no link is present. A separate blinking yellow LED
indicates activity.
Fibre Channel port: a lighted green LED indicates
link; off means no link. A separate green LED
indicates activity if it is lit, no activity if it is off.
Exhibit 1.4-1 Connectors, LEDs and power receptacle
air vents
Serial port
Reset switch
Ready/Fault LED
FC activity & link LEDs
Ethernet port
Fibre Channel ports
SCSI ports: a green LED on each port indicates
activity if is lit.
LEDs on the faceplate are:
A bicolor Ready/Fault LED is lighted green to
indicate ready, lighted yellow to show a faulted
condition, and off indicates not ready.
SCSI ports: a green LED on each port indicates
activity if is lit.
Fibre Channel port: a bicolor LED indicates FC
speed. If it is off, speed is 1-Gb; if it is green, 2-Gb, and
yellow indicates 4-Gb FC. A separate green LED
indicates activity if it is lit, no activity if it is off.
on the connector side and LEDs on the faceplate.
SCSI activity LEDs
SCSI ports
Power receptacle
10