ATTO Technology FibreBridge 2370E Installation And Operation Manual page 45

SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be negotiated.
Enabled allows wide transfer negotiation.
Default: enabled
set SCSIPortWideTransfer [sb] [enabled | disabled ]
Requires a SaveConfiguration command
get SCSIPortWideTransfer [sb]
SCSITargetLUNs
Controls the maximum number of SCSI LUNs per target the
FibreBridge queries during a SCSI bus scan.
Default: 8
set SCSITargetLUNs [sb] [8 | 64]
Requires a SaveConfiguration command
get SCSITargetLUNs [sb]
SCSITargets
Lists the physical devices connected and running on the
specified SCSI port.
SCSITargets [sb]
SerialNumber
Reports the FibreBridge serial number. The serial number,
unique for each FibreBridge, is a 13-character field. The first
seven alphanumeric characters are an abbreviation of the
FibreBridge name while the remaining six numbers are the
individual FibreBridge board's number.
get SerialNumber
SerialPortBaudRate
Configures/reports the baud rate for the FibreBridge RS-232
serial port or header. The number of data bits per character is
fixed at 8 with no parity.
Default: 115200
set SerialPortBaudRate [ 9600 |19200 | 38400 | 57600 |
115200]
Requires a SaveConfiguration Restart command
get SerialPortBaudRate
SerialPortEcho
Control/reports the status of the display of keyboard input.
When enabled, all non-control character keyboard input is
output to the display. Local ASCII terminal (or terminal
emulator) echo settings should be set to disabled while using
SerialPortEcho enabled
Default: enabled
set SerialPortEcho [enabled | disabled]
Requires a SaveConfiguration Restart command
get SerialPortEcho
SNMP
Controls whether or not SNMP functions on the FibreBridge.
Default: enabled
SNMP [enabled | disabled]
SNMPDumpMIB
Displays the contents of the ATTO FibreBridge private SNMP
MIB to the current CLI session. Consult your network
administrator for further assistance with SNMP.
SNMPDumpMIB
SNMPExtendedTraps
Controls Extended SNMP trap functioning such as device
transition and device error. Consult your network administrator
for further assistance with SNMP.
Default: disabled
set SNMPExtendedTraps [enabled | disabled]
get SNMPExtendedTraps
SNMPTrapAddress
Sets/displays the IP trap addresses and levels.Consult your
network administrator for further assistance with SNMP.
Index: value between 1 and 6
IPAddress: standard IP address for the host receiving
messages; must be in the same subnet as the
FibreBridge
Trap Level: severity required for an event to trigger a
trap:
None: no traps are sent to the address
ALL: all triggering events are sent
Warning: warning and critical events are sent
Critical: only critical events trigger a trap
Default: 0.0.0.0 none
set SNMPTrapAddress [Index] [IPAddress] [None | All |
Warning | Critical ]
get SNMPTrapAddress [index]
SNMPTraps
Controls SNMP trap functions.Consult your network
administrator for further assistance with SNMP.
Default: disabled
set SNMPTraps [enabled | disabled]
get SNMPTraps
SNTP
Controls whether the FibreBridge contacts a specified SNTP
time server to initialize or synchronize the time.
Default: enabled
set SNTP [enabled | disabled]
Requires a SaveConfiguration Restart command
get SNTP
xii