Command Explanations - ATTO Technology FibreBridge 2370E Installation And Operation Manual

Command explanations

AutoLogSense
Controls whether current data from log pages in a SCSI target
device is available automatically.
Default: disabled
set AutoLogSense [enabled|disabled]
Requires a SaveConfiguration command
get AutoLogSense
AutoMap
Automatically assigns a subset of source protocol LUNs to a
subset of target destination devices visible to the FibreBridge.
All previous maps are deleted.The unit reports a five-second
delay while it scans for devices. All previous maps are deleted.
FCMultiNode (FB 2400)
All other models and FC2400 with FCMultiNode disabled:
AutoMap
Requires a SaveConfiguration command
BootFibreDelay
Regulates the delay (in seconds) which the FibreBridge waits
until after startup before enabling Fibre Channel ports.
Default: 0 (no delay)
set BootFibreDelay [0-255]
Requires a SaveConfiguration command
get BootFibreDelay
BootScan
Provides dynamic mapping of SCSI devices to the Fibre
port/LUN combination via a SCSI bus scan at boot time. All
devices discovered during the bus scans are assigned to a Fibre
port, Fibre LUN combination until the next reset/power cycle.
This dynamic mapping replaces the current, static mapping of
the FibreBridge.
Default: disabled
set BootScan [enabled | disabled]
Requires a SaveConfiguration command
get BootScan
BootScanPorts (FB 2400)
Regulates the ports to be used for a boot scan.
Default: auto
set BootScanPorts [fp | all | auto]
Requires a SaveConfiguration command
get BootScanPorts
enabled: AutoMap <fp>
BridgeModel
Reports model and firmware information about the FibreBridge.
get BridgeModel
BridgeName
Specifies the eight-character ASCII name assigned to the
FibreBridge used to identify individual units. It is not the World
Wide Name. The string is alphanumeric, eight characters long,.
Changes take effect immediately.
Default: " "
set BridgeName [name]
get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are
recorded until the operation is completed.
ClearEventLog
ClearTraceLog
Clears the contents of the trace log. No events are recorded
until the operation is completed.
ClearTraceLog
Date
Sets/displays the date. The range is 01/01/2000 to 12/31/2099.
Default: 01/01/2000
set Date [MM] / [DD] / [YYYY]
Requires a SaveConfiguration command
get Date
DeleteAllMaps
Removes all mapped devices from the map table. Upon the
subsequent POST, if no maps are present, the default maps, if
present, are loaded.
DeleteAllMaps
Requires a SaveConfiguration command
DisplayEventLog
Displays the event log. The event log may be filtered using the
DisplayEventLogFilter command. The optional parameter n
is the number of lines to be displayed as a single page with no
user interaction. After the command has executed, use +, - or =
to scroll through the log. Type quit and press Enter to exit the
command.
DisplayEventLog <n>
vi