Internet Explorer Setup; Begin Initial Configuration - ATTO Technology FibreBridge 2370E Installation And Operation Manual

If you do not have a DHCP server, get an IP
address and subnet mask from your network
administrator, type it into the area provided, and
click on Next .
5 Click on Launch Browser.
Your browser points to the ATTO ExpressNAV
splash screen. If you use Internet Explorer as a
browser, you may continue on to the optional

Internet Explorer setup

to

Begin initial configuration

Internet Explorer setup
1 Open your browser
2 Select Internet Options .
3 In the Internet Options screen, select the
Security tab.
4 Click on the Trusted Sites icon.
5 Click on the Sites button.
6 In the text box Add this Web site to the zone ,
add the IP address of the appliance. You may
use wild cards.
Exhibit 2.0-1 Brackets to install the FibreBridge 2390R/D or 2400R/D into a rack.
Exhibit 2.0-2 Typical FibreBridge connectors, LEDs and power receptacle
air vents
below. If not, continue on
.
Ready/Fault LED
FC activity & link LEDs
Ethernet port
Serial port Fibre Channel ports
7 Click on Add.
8 Uncheck the Require server verification
check box.
9 Click OK.
10 At the bottom of the Internet Options box, click
on OK and close the box.
Begin initial configuration
1 The ExpressNAV interface welcome screen
appears. Click on Enter Here.
2 Type in the user name and password.
Note
The default values are user name root and
password Password. The user name is case
insensitive and the password is case
sensitive.It is best practice to change the
default user name and password. Refer to
Modify System Values
3 The ExpressNAV FibreBridge status page
appears. Continue to
.
SCSI activity LEDs
SCSI ports
on page 23.
Map Devices on page 17.
Power receptacle
14