Configure The Fibrebridge; Preliminary Steps; Page Descriptions - ATTO Technology FibreBridge 2370E Installation And Operation Manual

The ExpressNAV interface provides information and management for your FibreBridge. To use the FibreBridge
immediately, continue on to
A number of options are available based on your
FibreBridge model. Options described in this chapter
which are not available for your FibreBridge model are
greyed out in the ExpressNAV interface.
Default values are generally best for optimal
FibreBridge operation: you do not have to change any
of these parameters but you may go directly to
Devices on page 17.
Detailed explanations of these options are available
through the Help screen or by viewing the Command
Line Interface commands in
on page vi of the Appendix.
Note
The ExpressNAV interface is the preferred
method to manage your FibreBridge, but other
avenues are available. Refer to
options on page 27.

Preliminary steps

1 If you are not already in the ExpressNAV
interface, type the IP address of your
FibreBridge in a standard browser as found in
Using ExpressNAV
Here, type in your user name and password,
and click OK .

Page descriptions

Pages may contain information which cannot be
changed. Pages may include text boxes, radio buttons
or drop down boxes to allow you to make changes.
Red typeface items link to help information:
Status
Displays FibreBridge information
• Vendor
• Product
• Firmware revision number
• FibreBridge serial number
• Valid temperature range
• Current temperature
• Node names
• Port names
• Fibre Channel port status
• SCSI port status
• World Wide Identifiers of ports and nodes
15
ATTO Technology Inc. FibreBridge Installation and Operation Manual

3.0 Configure the FibreBridge

Map Devices on page 17.
Map
Command explanations
Interface
on page 27, click Enter
2 The Status page
appears. Click on the
element in the left-hand
menu to observe settings
or to change parameters.
Each page is described
below.
If a page has a Submit
3
button, click on that
button when you have
completed the changes
for that page.
4 When you have
completed changes, click
on the Restart menu
item.
a. Click the Restart
button.
A box tells you to
wait until the counter
gets to 0 when the browser refreshes.
Restarting the firmware may take a few
minutes.
b. If the browser does not refresh after the
counter gets to 0 , click the link to refresh it
manually.
Ethernet port configuration
Configures each port independently for the following
parameters:
• IP address
• IP gateway
• IP subnet mask
• Ethernet speed
Remote Management using SNMP or Email
notification
Refer to Monitor, Manage Remotely
information.
Serial port configuration
Configurable options are baud rate, echo and stop
bits.
on page 19 for