ATTO Technology FibreBridge 2370E Installation And Operation Manual page 42

FCSpeedLED2G (FB 2370)
Configures the FC speed LED. When enabled, the LED lights
for FC speeds of 2 Gb/sec. or 4 GB/sec. and turns off for an FC
speed of 1GB/sec. When disabled, the LED lights for an FC
speed of 4 Gb/sec.and turns off for FC speeds of 1 Gb/sec. or 2
Gb/sec.
Default: disabled
set FCSpeedLED2G [enabled | disabled]
get FCSpeedLED2G
FCWWName
Reports the Word Wide Name (WWN) of the FC interface. Each
FC port has an individual and unique WWN.
get FCWWN [PortNumber]
FirmwareRestart
Causes the FibreBridge to reboot, then re-initialize its
firmware.Use the forced option to override any CLI reservation
held by other sessions.
FirmwareRestart <forced>
Help
Displays a list of available commands. If command name is
specified, displays detailed command-specific information.
Help [command name]
IdentifyBridge
Enabling this option causes the Ready LED on the FibreBridge
to blink until the parameter is disabled.
Default: disabled
set IdentifyBridge [enabled | disabled]
get IdentifyBridge
Info
Displays version numbers and other production information for
key components within the FibreBridge
Info
IPAddress
Controls/displays the current FibreBridge IP address.If
IPDHCP is enabled, get command reports current IP address
assigned by the DHCP server.
Default: 10.0.0.1
set IPAddress [mp1] [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration Restart command
get IPAddress [mp1]
ix
ATTO Technology Inc. FibreBridge Installation and Operation Manual
IPDHCP
Selecting DHCP allows the FibreBridge to request an IP
address from the network. The network must have at least one
DHCP server.
Default: enabled
set IPDHCP [mp1] [enabled | disabled]
Requires a SaveConfiguration Restart command
get IPDHCP [mp1]
IPDNSServer
Controls the current DNS Server address. If
enabled, the DNS Server address is automatically detected. If
IPDHCP is disabled, you must set the address manually using
this command.
set IPDNSServer [xxx.xxx.xxx.xxx]
get IPDNSServer
IPGateway
Regulates/displays the current gateway. If
get command reports current IP gateway assigned by a DHCP
server.
Default: 0.0.0.0
set IPGateway [mp1] xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPGateway [mp1]
IPSubnetMask
Regulates/displays the current subnet mask. If
enabled, get command reports current subnet mask assigned
by DHCP server.
Default: 255.255.0.0
set IPSubnetMask xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPSubnetMask
IsReserved
Displays the reservation status of the current FibreBridge.
command: IsReserved
LogicalUnitAddressing
Controls the current device mapping method on the bridge.
When disabled, standard peripheral device mapping and
formatting is used. Target devices are only made visible to the
specific mapped Fibre Channel port. When enabled, static
device mapping and formatting is achieved with a discovery bus
scan at boot. All target devices are visible to all Fibre Channel
ports, with each port sharing a common Fibre Channel Node
Name.
Default: disabled
set LogicalUnitAddressing [enabled|disabled]
get LogicalUnitAddressing
IPDHCP is
IPDHCP is enabled,
IPDHCP is